Key takeaways
- SFA calls 5°C to 60°C the temperature danger zone. Keep chilled food at 4°C or below, frozen food at -18°C or below, and hot food above 60°C.
- SFA’s own record templates log chillers and freezers three times a day: before opening, between lunch and dinner, and just before closing.
- Every log needs the reading, the time, who took it and a supervisor’s check. Calibrate thermometers regularly and write down what you did when a reading was out of range.
- Digital sensors save time and catch overnight failures, but you still need someone to act on alerts and a record of corrective actions.
Last checked against SFA’s food safety pages, SFA’s FSMS record templates and the Environmental Public Health (Food Hygiene) Regulations: September 2026. This is a practical summary; your food hygiene officer and SFA have the final word.
Why temperature logs matter
SFA’s page on temperature control in cooked food explains the risk. Between 5°C and 60°C, bacteria such as Bacillus cereus, Clostridium perfringens and Staphylococcus aureus multiply quickly. Some form spores that survive cooking and reheating, so keeping food out of that range is the main control, not an extra.
A log turns that control into evidence. If a chiller fails overnight, a record shows when it was last in range and which food was affected. Our guide to digital checklist apps for restaurants covers moving these logs off paper. If an inspector asks how you manage temperatures, a signed log answers the question faster than any explanation. It also matters for grading: SFA’s SAFE framework, in Phase 1 since 19 January 2026, grades food establishments on their food safety track record, and SFA says more requirements for larger kitchens will follow in Phase 2. Our SFA inspection guide covers what officers look at.
Safe temperature ranges in Singapore
These are the figures SFA publishes on its food safety tips, its hot food guidance and in its record templates:
| What | Target | Source |
|---|---|---|
| Chillers and fridges | 4°C and below | SFA food safety tips |
| Freezers | -18°C or below | SFA food safety tips |
| Hot holding | Above 60°C | SFA hot food guidance |
| Reheating | At least 75°C internal for at least 2 minutes, once only | SFA hot food guidance |
| Cooling food for reuse | Below 5°C within 4 hours of cooking | SFA hot food guidance |
| Chilled fresh raw meat and uncooked fish | Not below 0°C and not above 4°C | Food Hygiene Regulations, definitions |
| Frozen raw meat | Not above -12°C | Food Hygiene Regulations, definitions |
The Environmental Public Health (Food Hygiene) Regulations define “chilled fresh” and “frozen” raw meat in those terms and contain rules on storage and refrigeration, thawing and transport. SFA’s daily check template also lists “chiller below 5°C, freezer below -12°C” as a pass. In practice, aim for the tighter targets: 0°C to 4°C in chillers and -18°C or colder in freezers gives you a margin when the door is opened during service.
How often to check
SFA publishes templates of records for use with Singapore Standard SS 583:2022, the code of practice for food safety management in food service. The chiller and freezer logs have three columns a day:
- Morning: before operations start.
- Afternoon: after the lunch crowd, before dinner.
- Night: just before closing.
That rhythm works for most restaurants because it catches the three risk points: an overnight failure, a unit struggling after a busy service and a problem developing before the kitchen goes dark. Add a check after deliveries if you receive large chilled or frozen orders, since a packed chiller takes time to recover. Our guide to commercial fridges and walk-in chillers covers sizing units. Build the checks into your opening and closing checklist so they are not forgotten on busy days.
What a temperature log should record
SFA’s templates give a good model. For each chiller and freezer, a monthly sheet with one row per day records:
- the date and time of each reading;
- the temperature at each check;
- who recorded it;
- a supervisor’s verification;
- a calibration line comparing a probe thermometer reading with the unit’s own gauge.
SFA also has a restaurant food temperature log for cooked items, recording the dish, its core temperature (the example uses 75°C for fried chicken and stir-fried vegetables) and who took it. The caterers’ version adds receipt number, time cooked, time the order left and time it arrived.
Keep one sheet per unit, labelled with the unit’s name or number, so a failure can be traced to the right chiller. Add a “corrective action” column even though the template does not have one; you will need it (see below).
Calibrating thermometers
A log is only as good as the thermometer. SFA’s templates describe two checks:
- Unit gauges: put a probe thermometer in the chiller or freezer and compare it with the built-in gauge. SFA allows a deviation of plus or minus 1°C.
- Food probes: at the beginning of each month, check the probe in ice water (0°C) and boiling water (100°C). Again, SFA allows plus or minus 1°C.
Replace a probe that fails, and record the calibration on the log. Clean and sanitise probes between raw and cooked food.
Choosing a restaurant thermometer
Most kitchens need two kinds. A probe thermometer checks food during cooking, cooling and reheating, and checks deliveries at the door. A commercial refrigerator thermometer stays inside each chiller or freezer, so staff can read the temperature without relying only on the unit’s built-in gauge. When buying, look for:
- a range that covers both freezer and cooking temperatures, reading in steps of 1°C or finer, so you can apply the plus or minus 1°C checks above;
- a probe that is easy to clean and sanitise between raw and cooked food;
- for fridge thermometers, a display staff can read at a glance;
- for digital sensors, alerts and battery status, as covered in the paper versus digital section below.
Keep a spare probe so a failed calibration check never leaves a shift without one.
Hot holding, cooling and reheating
Chillers get most of the attention, but hot food causes its share of problems. SFA’s hot food guidance says hot food should be kept above 60°C after cooking and during delivery, and should not be kept below 60°C for more than four hours after it was prepared. SFA notes that the four-hour rule is mandatory for catering establishments. Pre-heat bain-maries and hot-holding cabinets before food goes in.
For food you plan to reuse, SFA says to chill it to below 5°C within four hours of cooking, and its cooked food page suggests splitting large batches into smaller portions or shallow pans so they cool faster. Reheat to at least 75°C internal for at least two minutes, and only once.
Log hot-holding temperatures at least at the start of service and mid-service, and log cooling times for large batches such as stocks, curries and rice.
Paper logs versus digital sensors
| Paper log | Wireless sensors | |
|---|---|---|
| Cost | Very low | Hardware and often a subscription; get quotes |
| Overnight failures | Found at the morning check | Alert sent when the reading goes out of range |
| Accuracy of records | Depends on staff filling it in honestly | Automatic, time-stamped readings |
| Food core temperatures | Probe and paper | Usually still a probe; some systems log probe readings |
| Corrective actions | Written on the sheet | Still needs a person to respond and record |
Sensors earn their keep in kitchens with several chillers, walk-in cold rooms or expensive stock such as seafood and meat, where one overnight failure costs more than the system. Whatever you choose, test that alerts reach someone who will act at 2am. Keep calibrating sensors against a probe.
Corrective actions inspectors expect
SFA’s page on the Food Safety Management System describes the HACCP approach: set critical limits, monitor them, take corrective action when a limit is breached and keep records of all three. A log full of out-of-range readings with no action is worse than no log, because it shows you knew.
A simple response plan for each type of reading:
- Chiller slightly high (for example 5°C to 7°C): check the door seal, overloading and blocked vents; re-check in 30 minutes; move high-risk food to another unit if it does not recover.
- Chiller high for an unknown period: treat high-risk food as unsafe. Your food hygiene officer decides; when in doubt, throw it out and record what was discarded.
- Freezer above -12°C: check whether food has started to thaw. Do not refreeze thawed food; SFA’s thawing guidance says thawed food should not be refrozen.
- Hot holding below 60°C: reheat to 75°C once, or discard if it has been below 60°C beyond your time limit.
Record the action, who took it, and the follow-up reading. Log service calls for faulty units. SFA’s templates suggest chiller and freezer maintenance once every two months and cleaning once every two weeks; our cleaning schedule shows how to fit that in.
Fitting logs into your food safety system
Temperature logs are one part of a wider system that also covers suppliers, cleaning, pest control and staff health. Our food safety management system guide explains how the pieces fit, and SFA’s templates include records for each.
Your POS can help with the parts around the log. ChaChaCha, powered by AppsPOS, routes orders to a kitchen display by station with prep timers and order prioritisation, which helps the kitchen move food from pass to table without it sitting out. Recipe-level stock deduction and recipe costing show what a discarded batch costs, and reports help you spot patterns in waste after a chiller failure. For logging temperatures inside the POS, ask us to confirm what fits your setup. Pricing is quote-based; talk to us.